Benutzer:Peerco

Aus FunkFeuer Wiki
Wechseln zu: Navigation, Suche

Nodes

  • wurde von 14.Gruschaplatz (gru3 & gru3ost) in die 22.Wagrammerstr. umgezogen

Servers

  • p4 web foto video
  • p4 12kbps 32kHz stereo aacp stream (winamp5)
  • wrap

Hardware

  • WRAP Wireless Router Application Platform

Software

Docs

OpenVPN tunnel

leider ließ sich http://ipkg.funkfeuer.at/ipkg/1.7/0xff-openvpn-webif_1.7.1_mipsel.ipk nicht installieren

ipkg remove tcpdump
ipkg remove freifunk-tcpdump
ipkg install freifunk-tcpdump

root@gru3ost:~# cat /etc/init.d/S42openvpn

[..]

#create OpenVPN config

cat>$CONFIG_DIR/$VPN_IF.conf<<EOM
dev             $VPN_IF
proto           $ff_openvpn_proto
remote          $ff_openvpn_host
port            $ff_openvpn_port
ifconfig        $ff_openvpn_ip $ff_openvpn_netmask
route-up        /etc/openvpn/openvpn-webif-route-up.sh
up              /etc/openvpn/openvpn-webif-if-up.sh
down            /etc/openvpn/openvpn-webif-if-down.sh
up-restart
comp-lzo
script-security 2
verb 3
EOM

[..]

root@gru3ost:~# cat /etc/init.d/S45firewall

[..]

ins_nat() {
        LANNAT=
        case $WIFIDEV in "");;*)case $LANDEV in "");;*)if ! in_range $LANADR/$LA
NPRE;then
                use_nat

                # Setup alias and dest nat for an ethernet DMZ PC, e.g.
                # 172.31.255.254 on WLAN -> DMZ PC which has 192.168.1.2
                # Also add to olsrd.conf: "HNA4 172.31.255.254 255.255.255.255"
                IFS=\;
                devnum=0
                for dmz in $(nvram get ff_dmz); do
                        src=${dmz%[:,]*}
                        dst=${dmz#*[:,]}
                        ip addr add dev $WIFIDEV $src/32 label $WIFIDEV:$devnum
                        iptables -t nat -I PREROUTING -d $src -j DNAT --to $dst
                        iptables -I FORWARD -s ! $LANNET/$LANPRE -d $dst -j ACCE
PT
                        iptables -I FORWARD -s $dst -d ! $LANNET/$LANPRE -j ACCE
PT
                        iptables -I OUTPUT -o lo -s $src -d $src -j ACCEPT
                        iptables -I INPUT -i lo -s $src -j ACCEPT
                        devnum=$(( $devnum + 1 ))
                done
                unset IFS

                case $LANADR in "")
                        LANNAT=192.168.0.0/16
                ;;*)
                        LANNAT=$LANNET/$LANPRE
                ;;esac
                iptables -t nat -I POSTROUTING -o $WIFIDEV -s $LANNAT -d ! $LANN
AT -j MASQUERADE
                iptables -t nat -I POSTROUTING -o tap0 -s $LANNAT -d ! $LANNAT -
j MASQUERADE
        fi;;esac;;esac

        # Mask packets from these WLAN DHCP clients, so they can do
        # inet w/o OLSR unless HNA4 is to be used to accomplish this
        case $(nvram get ff_wldhcp_hna4) in 1);;*)
                ff_wldhcp=$(nvram get ff_wldhcp)
                case $ff_wldhcp in "");;*)
                        use_nat
                        IFS=\;
                        for wldhcp in $ff_wldhcp; do
                                iptables -t nat -I POSTROUTING -s ${wldhcp%[:,]*
} -j MASQUERADE
                        done
                        unset IFS
                ;;esac
        ;;esac
        case $WANDEV in "");;*)if in_range $WANADR/$WANPRE;then
                case $LANNAT in "");;*)
                        iptables -t nat -I POSTROUTING -o $WANDEV -s $LANNAT -d
! $LANNAT -j MASQUERADE
                ;;esac
        else
                use_nat
                iptables -t nat -I POSTROUTING -o $WANDEV -j MASQUERADE
        fi;;esac
}

[..]

WRAP & ALIX

Fonera

  • Freischalten Channel 13
  • Version von FreiFunk (Sven Ola) wien unter Fonera mit OLSR beschrieben ist
  • Kamikaze, da funkzioniert das nicht so wie bei der Freifunk Firmware von Sven Ola. Hier ist für die Freischaltung nur ein Eintrag im /etc/config/wireless unter config 'wifi-device' und zwar option 'country' '276' notwendig.
bei mir sieht es so aus

cat /etc/config/wireless

config 'wifi-device' 'wifi0'
        option 'type' 'atheros'
        option 'distance' '15000'
        option 'diversity' '0'
        option 'country' '276'
        option 'channel' '13'

config 'wifi-iface'
        option 'device' 'wifi0'
        option 'network' 'wlan'
        option 'mode' 'adhoc'
        option 'mcast_rate' '5500'
        option 'encryption' 'none'
        option 'rate' '5500'
        option 'ssid' 'v13.freiesnetz.www.funkfeuer.at'
        option 'bssid' '26:A7:D4:E4:4F:4D'

Misc

linksys

Legaler Grenzwert:     20   dBm  = 100 mW
Kabel/Stecker-Verlust:  3   dB
Antennengewinn:         8.5 dBi
Ergebnis:              58   qdBm =  28 mW

eth1      unknown transmit-power information.

          Current Tx-Power:14 dBm       (25 mW)
Legaler Grenzwert:     20   dBm  = 100 mW
Kabel/Stecker-Verlust:  3   dB
Antennengewinn:         6   dBi
Ergebnis:              68   qdBm =  50 mW

eth1      unknown transmit-power information.

          Current Tx-Power:17 dBm       (50 mW)

fonera

ath0      8 available transmit-powers :
          0 dBm         (1 mW)
          4 dBm         (2 mW)
          6 dBm         (3 mW)
          8 dBm         (6 mW)
          10 dBm        (10 mW)
          12 dBm        (15 mW)
          14 dBm        (25 mW)
          16 dBm        (39 mW)
          Current Tx-Power:16 dBm       (39 mW)

leistung allgemein

 0 dBm =   1 mW =  1 qdBm (24 dBi Antenne -5 dB Kabel/Stecker)
 1 dBm =   1 mW =  4 qdBm (24 dBi Antenne -5 dB Kabel/Stecker)
 2 dBm =   2 mW =  8 qdBm
 3 dBm =   2 mW = 12 qdBm (20 dBi Antenne -3 dB Kabel/Stecker) 
 4 dBm =   3 mW = 16 qdBm
 5 dBm =   3 mW = 20 qdBm
 6 dBm =   4 mW = 24 qdBm
 7 dBm =   5 mW = 28 qdBm
 8 dBm =   6 mW = 32 qdBm
 9 dBm =   8 mW = 36 qdBm
10 dBm =  10 mW = 40 qdBm
11 dBm =  13 mW = 44 qdBm
12 dBm =  16 mW = 48 qdBm
13 dBm =  20 mW = 52 qdBm
14 dBm =  25 mW = 56 qdBm
15 dBm =  32 mW = 60 qdBm (8 dBi Antenne -3 dB Kabel/Stecker)
16 dBm =  40 mW = 64 qdBm
17 dBm =  50 mW = 68 qdBm (4 dBi Antenne -1 dB Kabel/Stecker)
18 dBm =  63 mW = 72 qdBm
19 dBm =  79 mW = 76 qdBm
20 dBm = 100 mW = 80 qdBm (0 dBi Antenne -0 dB Kabel/Stecker)
21 dBm = 126 mW = 84 qdBm
22 dBm = 158 mW = 88 qdBm
23 dBm = 200 mW = 92 qdBm
24 dBm = 251 mW = 96 qdBm

Notizen

gru3 - Gruschaplatz 3 - alte GPS 48.19457925291452;16.283304691314697 frontend 48 11 41 16 17 0
gru3ost - Gruschaplatz 3 - alte GPS 48.194548857439884;16.28334492444992 frontend 48 11 40 16 17 1
wag23 - Wagramerstrasse 23/1 - GPS 48.235596701477355;16.422221660614014 frontend 48 14 8.25 16 25 19.96
wag23ost - Wagramerstrasse 23/1 - GPS 48.23552077360733;16.42235577106476 frontend 48 14 7.7 16 25 20.6